Yanmar 3HM Manual do Utilizador descarregar pdf (Página 13)

Note

1) Fix the wire to the cable clamp of the F.O. filter side.

2) Cable connector has M5 thread.

2-b)

After completing of wiring, check the following

points:

2-b)-1.

That the remote control lever and speed control lever

can be moved smoothly through the whole stroke.

2-b)-2

That the idle speed adjuster regulates the speed to

850-900 rpm, after all preparations for starting the

engine have been completed.

1. Cable clamp

3) Clutch Control

3-a)

Cone Clutch (for 1GM, 2GM, 3GMD)

3-a)-1.

Remove the spring joint from the operation lever.

3-a)-2.

With the spring joint disconnected from the operation lever,

move the operation lever forward and reverse, to make sure

that the strokes from the neutral position are the same.

3-a)-3.

Attach the spring joint to the operation lever 60mm from the shaft lever center.

The stroke from the neutral position moves through a distance of 24.4 to 35.Ohm. When the

spring joint is attached to the hole 52mm from the center of the shift lever, these strokes must

be 21.1-30.Ohm.

Note

The operation lever may not move smoothly when there is no lubrication oil in the clutch

case.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Sem comentários

Yanmar 3HM Manual do Utilizador Página 13