Yanmar 1GM10V Especificações descarregar pdf (Página 21)

3. Operation

21

3.3 Operating your engine

To prevent exhaust gas poisoning, ensure

good ventilation during operation. Install

ventilation windows, ports or ventilators in

the engine room.

Never touch or allow your clothes to touch

the moving parts of the engine during

operation. If the front drive shaft, V-belt,

propeller shaft, etc. catches your body or

clothes, serious injury may result. Check

that no tools, cloth, etc. are left on or

around the engine.

The engine is very hot during operation

and immediately after stopping, especially

the exhaust pipe. Avoid burns! Never

touch or allow your clothes to touch any

part of the engine.

3.3.1 Inspection Before Starting

Before starting the engine, make it a daily

rule to conduct the following inspections:

(1) Visual Checks

Check for the following:

1. Lube oil leakage from the engine

2. Fuel oil leakage from the fuel system

3. Water leakage from the cooling water

system

4. Damage to parts

5. Loosening or loss of bolts

If any problem is found, do not operate the

engine before completing repairs.

(2) Checking and Resupplying Fuel Oil

Check the fuel level inside the fuel tank

and supply with the recommended fuel, if

necessary. (See 3.2.1)

002540-00E

002696-00E

(3) Checking and Resupplying Engine

Lube Oil

1. Check the engine oil level with the oil

dipstick.

2. If the oil level is low, supply with the

recommended lube oil using the filler

port. Supply oil up to the top mark on

the oil dipstick. (See 3.2.2)

(4) Checking and Resupplying Clutch

Lube Oil

1. Check the clutch oil level with the oil

dipstick.

2. If the oil level is low, supply with the

recommended lube oil using the filler

port. Supply oil up to the top mark on

the oil dipstick. (See 3.2.3)

(5) Checking the Remote Control Han-

dle

Be sure to check that the remote control

handle lever moves smoothly before use.

If it is hard to operate, lubricate the joints

of the remote control cable and also the

lever bearings.

If the lever comes out or there is play in

the lever, adjust the remote control cable.

(See 4.3.4(3))

(6) Checking the Alarm Devices Elec-

tric Operation

When operating the key switch, check that

the alarm devices work normally. (See

2.5.1(3))

(7) Preparing Fuel, and Lube Oil in

Reserve

Prepare sufficient fuel for the day’s

operation. Always store lube oil in

reserve (for at least one refill) onboard, to

be ready for emergencies.

GM OPERATION.book 21 ページ２００４年１０月４日　月曜日　午前１１時１１分

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Comentários a estes Manuais

Sem comentários