
3. Operation
25
(3) Are there abnormal vibrations or
noise?
Do not operate at speeds which produce
violent vibrations. Depending on the hull
structure, engine and hull resonance may
suddenly become great at a certain
engine speed range, causing heavy
vibrations.
Avoid operation in this speed range. If
you hear any abnormal sounds, stop the
engine and inspect.
Electric Operation
(4) Alarm buzzer sounds during oper-
ation.
If the alarm buzzer sounds during
operation, lower the engine speed
immediately, check the warning lamps,
and stop the engine for repairs.
(5) Is there water, oil, or gas leakage,
or are there any loose bolts?
Check the engine room periodically for
any problems.
(6) Is there sufficient fuel oil in the fuel
oil tantk?
Replenish fuel oil in advance to avoid
running out of fuel during operation.
(7) When operating the engine at low
speed for long periods of time,
race the engine once every 2
hours.
Note: Racing the Engine
With the clutch in NEUTRAL,
accelerate from the low speed
position to the high speed position
and repeat this process about 5
times. This is done to clean out
carbon from the cylinders and the
fuel injection valve.
Neglecting to race the engine will
result in poor exhaust colour and
reduce engine performance.
Electric Operation
Never turn off the battery switch or
spark the battery cable during
operation. Damage to parts in the
electric system will result.
3.3.5 Stopping the Engine
Stop the engine in accordance with the
following procedures:
1. Put the remote control handle in NEU-
TRAL.
2. Be sure to race the engine before stop-
ping it. (See 3.3.4(7))
3. Cool down the engine at low speed
(approximately 1000 rpm) for about 5
minutes.
Stopping the engine suddenly while
operating at high speed will cause the
engine temperature to rise quickly,
causing deterioration of the oil and
sticking of parts.
002550-00E
002550-00E
Engine stopping by engine stop cable
Engine stop cable
002548-00E
GM OPERATION.book 25 ページ 2004年10月4日 月曜日 午前11時11分
Comentários a estes Manuais