Yanmar 6LPA-STZP2 Especificações descarregar pdf (Página 65)

PERIODIC MAINTENANCE

6LPA Series Operation Manual 59

12/05

Replacing the Fuel Filter Element

Figure 3

1 – Mounting Screw (2 used)

2 – Housing

3 – Alarm Switch

4–O-Ring

5 – Filter Element

1. Close the fuel cock of the fuel tank.

2. Remove the two mounting screws

(Figure 3, (1)) and the housing

(Figure 3, (2)).

3. Drain the fuel from the fuel drain cock

on the bottom of the fuel / water

separator.

4. Disconnect the alarm switch harness.

Figure 4

5. Remove the alarm switch (Figure 3)

with a wrench.

6. Remove the filter element

(Figure 3, (5)) with a filter wrench.

7. Install the alarm switch to the new fuel

filter.

8. Apply a thin film of clean diesel fuel to

the sealing surface of the new filter

gasket.

9. Install new filter and tighten hand-tight.

Use a filter wrench and tighten to

14.7 - 19.6 N·m (130.1 - 173.5 in.-lb).

10.Install filter and tighten hand-tight.

11.Connect the alarm switch harness.

12.Install the housing and mounting

screws.

13.Bleed the fuel system. See Bleeding

the Fuel System on page 29. Dispose

of waste properly.

14.Start engine and check for leaks.

(5)

(4)

(3)

(2)

(1)

0004915

Component Part No.

Fuel Filter Element 119773-55710

0004897

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 105 106

Comentários a estes Manuais

Sem comentários

Yanmar 6LPA-STZP2 Especificações Página 65

Comentários a estes Manuais

Manuais e produtos relacionados com Motor Yanmar 6LPA-STZP2