Yanmar 6LPA-STZP2 Especificações descarregar pdf (Página 69)

PERIODIC MAINTENANCE

6LPA Series Operation Manual 63

12/05

Perform the following maintenance every

250 hours or one year of operation,

whichever comes first.

• Replacing the Fuel Filter Element

• Changing the Coolant

• Checking or Replacing the Zinc

Anodes

• Adjusting the Remote Control Cable

• Cleaning the Turbocharger

• Cleaning the Air Cleaner

Replacing the Fuel Filter Element

See Replacing the Fuel Filter Element on

page 59.

Changing the Coolant

Replace the coolant every year.

Note: If Long Life coolant is used,

replace coolant every 2 years.

1. Drain the fresh water cooling system.

See Drain Seawater Cooling System on

page 74.

2. Fill the cooling system with clean

coolant. See Checking and Adding

Coolant on page 34.

Checking or Replacing Zinc Anodes

Inspect and replace the zinc anodes

periodically.

NOTICE

If zinc anodes are not replaced

periodically, corrosion and engine damage

will result.

1. Close the seacock.

2. Drain the seawater cooling system. See

Drain Seawater Cooling System on

page 74.

Figure 8

Figure 8

3. Remove all the plugs ((Figure 9, (1)),

(Figure 10, (3)), (Figure 11, (4)),

(Figure 12, (2)) and (Figure 13, (2)))

labeled ZINC (Figure 8, (1)).

4. Measure the remaining zinc in the plug.

Replace the zinc anode when it is less

than one-half its original size. See chart

for sizes.

5. Install a new zinc in a new plug.

NOTICE

NEVER use sealing tape to install the

zinc anode. The anode must make

metal-to-metal contact.

6. Install plug.

7. Open the seacock and check for leaks.

Figure 9

Fuel Cooler

Figure 9

Every 250 Hours of Operation

(1)

0004896

(

1

)

0004918

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 105 106

Comentários a estes Manuais

Sem comentários